Description
A ready-to-go solution to connect a Link ECU to your Gen 3 drive-by-wire LS V8 (LS1 and LS6). The bundle also includes a fuse box and relay.
Kit contents
- G4X XtremeX ECU (8 injector and 8 ignition drives) – 109-4000
- Terminated engine harness GM LS Gen 3/4 – 101-0300
- LS drive-by-wire adapter loom – 101-0304
- LS MAP adapter harness – 101-0302
- LS Gen 3 knock adapter loom – 101-0305
- LS fuse box and relay – 101-0310
Advanced XtremeX features
- Fully programmable e-throttle control, including gear shift throttle blip and antilag
- Cruise control
- Two independent CAN modules
- 30 general purpose tables (up from 20)
- All motorsport features, including full gear shift control, cruise control, traction control, antilag and launch control
- Advanced closed loop lambda strategy and dual bank lambda control
Terminated engine harness
- Designed to match the PC Link base map I/O setup, so most engines can be made to run with minimal adjustments
- “Spares” connector with spare I/O for sensors, switches or custom additions
- Chassis connector with sealed JPT terminals (TE Connectivity JPT family); mating connector specs are provided
With the fuse box, the bundle includes the main chassis flying leads (unterminated wires) for essential power and control:
- Large red “Batt+” wire (ECU main power)
- Red-green “Fan” wire (ECU-controlled +12V to the cooling fan), rated 20 A continuous
- Red-blue “Fuel Pump” wire (ECU-controlled +12V), 20 A continuous
- Grey-black “Ign Sw” wire (to the ignition switch)
Dedicated harness connectors
- Pedal: for a DBW pedal, with 5V, sensor ground and two analog voltage inputs
- CAN2: for CAN devices such as lambda modules, displays, keypads, etc.
- MAP: compatible with Link MAP sensors; adapter available for factory LS MAP sensors
- Knock: up to two knock sensors, with adapters available for factory Gen 3 or Gen 4 sensors
- Alternator: for “F Body” alternators, provides the exciter/lamp wire to terminal B
- Transmission (“Trans”): for reverse switch, digital input or other functions needing a cabin signal
- IAC: for a 4-wire stepper IAC; if no IAC is used, these channels can be used for other functions (boost valve, NOS, etc.)
- TPS: for cable throttle sensors; can be repurposed when using DBW
- DBW: for electronic throttle bodies, with analog inputs, 5V and sensor ground; can be repurposed on cable throttle engines
Good to know
- For Gen 4 LS engines, bundle 109-9025B is the better choice.
A PC Link base map for this bundle and the online harness manual are available.






Reviews
There are no reviews yet.