Description
G5 Plug-in ECUs offer the latest in engine management technology, designed to easily maximise the potential of your car. They mount in the factory ECU location and installation is a breeze: they plug straight into the factory wiring loom, with no adapter harness required.
Designed for right-hand drive (RHD) Toyota 86, Subaru BRZ and Scion FR-S. It controls both direct and port injection and comes with a startup map to get the engine running quickly.
- Please check your connector matches the header in the listed photo before purchasing.
- This ECU works with both manual and automatic transmissions.
- Most factory features are supported.
- Built-in e-throttle (drive by wire) control.
- Due to the very tight factory ECU location, LHD and RHD mounting methods differ: this version is for right-hand drive (RHD) vehicles only. An LHD version is available under part number 241-4200.
Suitable applications
- Toyota 86 ZN6 with 4U-GSE/FA20 engine, 2012–2021
- Toyota GT86 ZN6 with 4U-GSE/FA20 engine, 2012–2021
- Subaru BRZ ZC6 with 4U-GSE/FA20 engine, 2012–2020
- Scion FR-S with 4U-GSE/FA20 engine, 2012–2016
2017+ models
2017+ models have some differences from earlier cars and will not run with the sample maps supplied in PC Link and the standard plug-in hardware:
- The crank sensor is Hall effect instead of reluctor: change Trigger 1 Type from 'Reluctor' to 'Optical/Hall' and set Trigger 1 Pull-up to ON.
- The DI fuel pressure sensor is different (4 pins instead of 3): it requires an 8.2 kΩ pull-up resistor wired between C7 (An Volt 4) and 5 V, the DI Fuel Pressure source changed from An Volt 3 to An Volt 4 and the calibration set to 0 kPa at 4.06 V and 30000 kPa at 0.46 V.
ECU features
- Direct and port injection control
- Dual CAN bus
- E-throttle control
- Flex fuel
- Built-in trigger oscilloscope
- 3-axis accelerometer
- Selectable temperature input pull-ups
- Flexible engine protection limiters
- CAN keypad control
- VVT-i control
- Open loop boost control
- Closed loop boost control
- Dual closed loop lambda
- Direct automatic transmission control
- Built-in DTM4 CAN cable
- Compatible with all leading aftermarket dashes via CAN or serial stream
- 512 MB of logging memory
Motorsport features
- Nitrous control
- Launch control
- Anti-lag
- Cruise control
- Traction control
- Race timer and power management
- Gear shift control
- Paddle shift control
Specifications
- 2 x CAN bus channels
- USB-C tuning connection
- Inputs and outputs: full list in the installation manual
- Dimensions: 460 mm (L) x 115 mm (W) x 45 mm (H)
- Weight: 1,000 g
- Billet CNC aluminium enclosure
- Operating voltage range: 6.5–24 V
- Maximum input voltage: 36 V
- Maximum continuous current draw: 11.5 A
Box contents
- TGT86 plug-in ECU
- USB-C connection cable
- Locking USB-C extension cable
- 2 x M6 screws
- DTM4 CAN connection cable (pre-installed in enclosure)
- Link stickers
- Plug-in manual card
- Product registration card









Reviews
There are no reviews yet.